Jablotron JA-121E-BK Bus Buitentoetsenbord met Lezer, Zwart
Jablotron JA-121E-BK is een zwarte bus buitentoetsenbord met lezer, RFID and MIFARE frequentie.
Beschikbaarheid: Op voorraad
SKU
JA-121E-BK
Jablotron JA-121E-BK Bus Buitentoetsenbord met Lezer
Het zwarte toetsenbord biedt een unieke combinatie van modern design met dual media reading technologie. De voorkant is gemaakt van speciaal synthetisch gehard glas dat niet gemakkelijk kan worden bekrast door toetsen of andere harde voorwerpen.
Specificaties JA-121E-BK:
- Stroomvoorziening: vanaf bedieningspaneel
- Stroomverbruik als back-up (inactief): 35 mA
- Maximaal stroomverbruik: 105 mA
- RFID-frequentie: 125 kHz
- MIFARE-frequentie: 13,56 MHz
- Omgeving: Buiten algemeen
- Ingress Protection Code: IP 55
- Operationeel temperatuurbereik: -25 °C tot +70 °C
- gen: 96 x 67 x 19 mm
- Gewicht: 170 g
Klantenreviews
Product Vragen
Hi,
Would it be possible to control multiple PG outputs with JA-121E via codes in Jablotron 100? I would like to control multiple outputs (small and big gate, door) already in the system. Example input code 123456 to open PG1, 123457 PG2 and so on.
My tech who installed the system could not figure it out...
Thx for the feedback!
Nejc
Would it be possible to control multiple PG outputs with JA-121E via codes in Jablotron 100? I would like to control multiple outputs (small and big gate, door) already in the system. Example input code 123456 to open PG1, 123457 PG2 and so on.
My tech who installed the system could not figure it out...
Thx for the feedback!
Nejc
Vraag van: Nejc Rajtmajer op 15 sep 2023 10:22
Hello, we have not tested it yet but you could try the following.
Please note that the JA-121E can only do PG control in this situation.
1. Select your function - probably PGon/PGoff;
2. Select the PG's you want to control;
3. Create a user (code) for each PG;
4. Make sure each user/code is authorised for a specific PG.
Regards
Please note that the JA-121E can only do PG control in this situation.
1. Select your function - probably PGon/PGoff;
2. Select the PG's you want to control;
3. Create a user (code) for each PG;
4. Make sure each user/code is authorised for a specific PG.
Regards
Answer by: Frank Ligthart (Admin) on 16 sep 2023 12:10
Another thing:
1. Make sure you work with the latest firmware in the control panel and keypad;
2. The PG output should be on 'Pulse' reaction.
Regards
1. Make sure you work with the latest firmware in the control panel and keypad;
2. The PG output should be on 'Pulse' reaction.
Regards
Answer by: Frank Ligthart (Admin) on 18 sep 2023 10:29
Files
Gerelateerde producten
